Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 115)

OMS OMNEO Main Station Configuration | Audio menu | en 115
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
Low Frequency Field
Use the Low Frequency field to set the low point of the frequency band.
Available selections for this field: 50.0 Hz, 31.5 Hz, 15.6 Hz, or 0 Hz.
High Frequency Field
Use the High Frequency field to set the high point of the frequency band.
Available selections for this field: 22.0 kHz, 16 kHz, 8 kHz, or 4 kHz.
23.4 Mic options
The Mic Options screen is used to configure various mic settings.
Figure 23.9: Configuration | Audio | Mic Options Screen
Mic Mute Mode Field
Use the Mic Mute Mode field to select the actions of the Mic Mute key .
Available selections for this field are:
Disabled By disabling the mic mute key, users are not able to mute the microphone
from the front panel.
Momentary The mic is muted for only as long as the mic mute key is held on.
Toggle
(default) The mic mute key is enabled. In this mode, pressing the mic mute key
toggles the mic mute state on and off.
Hot Mic Check Box
The Hot Mic check box determines whether hot mic is active on the device. When enabled,
audio from the mic goes out to the matrix without regard to the talk key state.
Panel Mic Gain Field
Use the Panel Mic Gain field to set the gain level the panel mic operates.
Headset Mic Gain Field
Use the Headset Mic Gain field to set the gain level the headset mic operates.
23.5 Tone generator
The Tone Generator checks the audio path from the device to the matrix. Use this screen to
enable or disable the tone and set the frequency of the tone.
Figure 23.10: Configuration | Audio | Tone Generator Screen
Tone Enabled Check Box
The Tone Enabled check box determines if the tone generator is on or off.
Tone Frequency Field
Use the Tone Frequency field to set the tone frequency sent across the audio path.
Available options are:
–
500 Hz (default)