Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 25)

OMS OMNEO Main Station System configuration | en 25
Bosch Security Systems, LLC Technical Manual 01-2021 | 03 | F.01U.380.820
8 System configuration
8.1 Configure network ports
To access the network configuration menu , do the following:
1. Connect a power cord to the power connector on the rear panel of the device.
The unit turns on, the display becomes active, and the device home screen appears.
2. Press the MENU button on the keypad.
The Menu Home screen appears.
3. Navigate to the Configuration icon .
4. Click the ENC2 encoder knob .
The Configuration menu appears.
5. Navigate to the Network icon .
6. Click the ENC2 encoder knob .
The Network menu appears.
8.2 Configure the Control interface
Use the Control Port screen to configure the network interface for AZedit.
To configure the control port interface , do the following:
1. Navigate to the Control Port icon .
2. Click the ENC2 encoder knob .
The Control Port Configuration screen appears.
3. Enter the IP address of the control port .
4. Enter the Netmask .
5. Enter the Gateway address , if applicable.
6. Enter the DNS server address , if applicable.
7. Click the ENC1 encoder knob to exit.
A confirmation to save or discard changes appears.
8. Rotate the ENC2 encoder knob to the desired action .
9. Click the ENC2 encoder knob to confirm .