Telex RTS OMS OMNEO Main Station Advanced Digital Partyline Intercom Base (5-Pin Female) - Manual (Page 26)

26 en | System configuration OMS OMNEO Main Station
01-2021 | 03 | F.01U.380.820 Technical Manual Bosch Security Systems, LLC
8.3 Configure the OMNEO interface
To configure the OMNEO interface from the front panel , do the following:
1. Navigate to the OMNEO icon .
2. Click the ENC2 encoder knob .
The OMNEO Configuration screen displays.
3. Enter the Audio IP address used to transmit and receive audio across the network.
i
Notice!
The Audio IP address and the Control IP address should be in the same subnet. OMS displays
a warning message if these addresses are not on the same subnet.
4. Enter the Control IP address used by the OMNEO controller to access the network.
5. Enter the Netmask address for the OMNEO interface.
6. Enter the Gateway address for the OMNEO interface, if applicable.
7. Enter the DNS Server address to which the OMNEO has access.
8. Enter a recognizable device name for the OMNEO network connection.
9. Enter the domain for the OMNEO network. By default, the domain is left blank.
10. Select the Use Static check box to enable static IP addressing.
i
Notice!
If the Use Static check box is not selected, DHCP/Link-local is used and some of the
remaining fields are automatically populated.
11. Click the ENC1 encoder knob to exit.
A confirmation to save or discard changes appears.
12. Rotate the ENC2 encoder knob to the desired action .
13. Click the ENC2 encoder knob to confirm .