beautypg.com

Cable connections – ProSoft Technology MVI71-DFNT User Manual

Page 82

background image

Reference

MVI71-DFNT ♦ PLC 5

User Manual

EtherNet/IP Client/Server Communication Module

Page 82 of 175

ProSoft Technology, Inc.

February 3, 2011

5.3 Cable Connections

The MVI71-DFNT module has the following functional communication

connections installed:

One Ethernet port (RJ45 connector)

One RS-232 Configuration/Debug port (RJ45 connector)

5.3.1 Ethernet Connection

The MVI71-DFNT module has an RJ45 port located on the front of the module,

labeled Ethernet, for use with the TCP/IP network. The module is connected to

the Ethernet network using an Ethernet cable between the module’s Ethernet

port and an Ethernet switch or hub.

Note: Depending on hardware configuration, you may see more than one RJ45 port on the

module. The Ethernet port is labeled Ethernet.

Warning: The MVI71-DFNT module is NOT compatible with Power Over Ethernet (IEEE802.3af /

IEEE802.3at) networks. Do NOT connect the module to Ethernet devices, hubs, switches or

networks that supply AC or DC power over the Ethernet cable. Failure to observe this precaution

may result in damage to hardware, or injury to personnel.

Important: The module requires a static (fixed) IP address that is not shared with any other device

on the Ethernet network. Obtain a list of suitable IP addresses from your network administrator

BEFORE configuring the Ethernet port on this module.