beautypg.com

ProSoft Technology MVI71-DFNT User Manual

Page 25

background image

MVI71-DFNT ♦ PLC 5

Installing and Configuring the Module

EtherNet/IP Client/Server Communication Module

User Manual

ProSoft Technology, Inc.

Page 25 of 175

February 3, 2011

2.2.1 [Module]

This section provides the module with a unique name, identifies the method of

failure for the communications for the module if the processor is not in run, and

describes how to initialize the module upon startup.

0 to 80

characters

Module Name

This parameter assigns a name to the module that can be viewed using the

configuration/debug port. Use this parameter to identify the module and the

configuration file.

0 to 3999

Read Register Start

This parameter specifies the starting register address of a block of data registers

to transfer from the module to the processor.

0 to 3960

Read Register Count

This parameter specifies the number of registers to be transferred from the

module to the processor.

0 to 3999

Write Register Start

This parameter specifies the starting register address of a module register block

where data transferred from the processor will be stored.

0 to 3960

Write Register Count

This parameter specifies the number of registers to transfer from the processor to

the module.

0 through 65535

Failure Flag Count

This parameter specifies the number of successive transfer errors that must

occur before halting communication on the application port(s). If the parameter is

set to

0, the application port(s) will continue to operate under all conditions. If the

value is set larger than

0 (1 to 65535), communications will cease if the specified

number of failures occur.