ProSoft Technology MVI71-DFNT - Manual (Page 54)

Diagnostics and Troubleshooting MVI71-DFNT ♦ PLC 5
User Manual EtherNet/IP Client/Server Communication Module
Page 54 of 175 ProSoft Technology, Inc.
February 3, 2011
Press [I] to open the Client Command List menu. Use this command to view the
configured command list for the module.
Opening the Client Command List Menu
On the Diagnostics Menu this is referred to as Receive Module Configuration.
Transferring the Configuration File from the PC to the Module
Press [R] to receive (download) the configuration file from your PC to the module
and store the file on the module’s Compact Flash Card (Personality Module) or
Flash RAM.
Press
[Y] to confirm the file transfer, and then follow the instructions on the
terminal screen to complete the file transfer process.
After the file has been successfully downloaded, the module will restart the
program and load the new configuration information. Review the new
configuration using menu commands [6] and [0] to verify that the module is
configured correctly.
On the Diagnostics Menu this is referred to as Send Module Configuration.
Transferring the Configuration File from The Module to the PC
Press [S] to send (upload) the configuration file from the module to your PC.
Press [Y] to confirm the file transfer, and then follow the instructions on the
terminal screen to complete the file transfer process.
After the file has been successfully uploaded, you can open and edit the file to
change the module’s configuration.
Press [U] to reset the status counters for the Client and/or server(s) in the
module.
Resetting Diagnostic Data
Press [V] to view version information for the module.
Viewing Version Information
Use this command to view the current version of the software for the module, as
well as other important values. You may be asked to provide this information
when calling for technical support on the product.
Values at the bottom of the display are important in determining module
operation. The Program Scan Counter value is incremented each time a
module’s program cycle is complete.
Tip: Repeat this command at one-second intervals to determine the frequency of program
execution.