ProSoft Technology MVI71-DFNT - Manual (Page 75)

MVI71-DFNT ♦ PLC 5 Reference
EtherNet/IP Client/Server Communication Module User Manual
ProSoft Technology, Inc. Page 75 of 175
February 3, 2011
This block is sent from the PLC processor to the module when the module is
required to perform a warm-boot (software reset) operation. This block is
commonly sent to the module any time configuration data modifications are made
in the controller tags data area. This causes the module to read the new
configuration information and to restart. The following table describes the format
of the control block.
Warm Boot Block (9998)
Block Request
Offset Description Length
0 9998 1
1 to 63 Not used 63
This block is sent from the PLC processor to the module when the module is
required to perform the cold boot (hardware reset) operation. This block is sent to
the module when a hardware problem is detected by the ladder logic that
requires a hardware reset. The following table describes the format of the control
block.
Cold Boot Block (9999)
Block Request
Offset Description Length
0 9999 1
1 to 63 Not used 63