TA Triumph-Adler DCC 6526L User Manual
Page 62
Preparation before Use
2-17
2
Use the procedure below to setup the TCP/IP (IPv4) setting.
1
Press the System Menu/Counter key on the main
unit operation panel.
When you are performing user management and
have not logged in, a login screen will appear.
Then, enter the Login User Name and Login
Password to log in.
NOTE:
Refer to Character Entry Method on
Appendix-8 for details on entering characters.
2
In the Sys. Menu/Count. menu, press the or
key to select [System], and then press the OK key.
IMPORTANT:
To make the settings, you must have
logged in using a Login User Name with administrator
privileges.
The default settings of the Login User Name and Login
Password are both "2600".
If you have logged in using a Login User Name without
administrator privileges, the screen will display
Administrator only.
and return to the standby screen.
3
In the System menu, press the or key to
select [Network Setting].
4
Press the OK key. The Network Setting menu
appears.
5
Press the or key to select [TCP/IP Settings].
Login User Name:
L
b
********************
Login Password:
[ Login
]
Sys. Menu/Count.: a
b
1 Report
2 Counter
*********************
[
Exit
]
3 System
Administrator only.
System:
a
b
*********************
2 I/F Block Set.
3 Security Level
[
Exit
]
1 Network Setting
Network Setting:
a
b
*********************
2 NetWare
3 AppleTalk
[
Exit
]
1 TCP/IP Settings