TA Triumph-Adler DCC 6526L - Manual (Page 498)

Appendix-15
Choosing the Appropriate Paper
This section describes guidelines for choosing paper.
Condition
Avoid using paper with bent corners or that is curled, dirty, or torn. Do not use paper that has a rough surface
or paper fiber lint, or that is especially delicate. Use of paper in any of these conditions will not only deliver poor
copies but may also cause jams and shorten the useful life of the machine. Choose paper with a smooth and
even surface; however, avoid coated paper or paper with a treated surface as it may damage the drum or fusing
unit.
Ingredient
Do not use paper such as paper that has been coated or surface-treated or paper that contains plastic or
carbon. These paper may produce harmful fumes from the heat of printing and may damage the drum.
Be sure to use the standard paper that contains at least 80% pulp, i.e., not more than 20% of the total paper
content consists of cotton or other fibers.
Supported Paper Sizes
Paper of the following sizes is supported by the machine.
Measurements in the table take into account a ±0.7 mm dimensional accuracy for length and width. Corner
angles must be 90° ± 0.2°.
Multi Purpose Tray
Cassette 1 or Multi
Purpose Tray
B6 (128 × 182 mm) Letter
ISO B5 (176 × 250 mm) Legal
Envelope #10 (Commercial #10) (4 1/8 × 9 1/2") Statement
Envelope #9 (Commercial #9) (3 7/8 × 8 7/8") Executive
Envelope #6 (Commercial #6 3/4) (3 5/8 × 6 1/2") Oficio II
Envelope Monarch (3 7/8 × 7 1/2") A4 (297 × 210 mm)
Envelope DL (110 × 220 mm) A5 (210 × 148 mm)
Envelope C5 (162 × 229mm) A6 (105 × 148 mm)
Hagaki (100 × 148mm) B5 (257 × 182 mm)
Oufuku Hagaki (148 × 200 mm) Folio (210 × 330 mm)
Youkei 4 (105 × 235 mm) 16K (273 × 197 mm)
Youkei 2 (114 × 162 mm)
Size Entry (70 × 148 to 216 × 356 mm)