Magnum Energy AGS Network (ME-AGS-N) - Manual (Page 99)

93 © 2012 Magnum Energy, Inc.
12.0 ME-AGS-N Remote Troubleshooting
12.3.1 How to Clear AGS Faults
• ME-RC – go to the AGS: 01 AGS Control menu and select AGS= Off.
Note: After the fault clears and the reason for the fault is determined,
be sure to re-enable the AGS to autostart. Go to the AGS: 01 AGS
Control menu and select AGS= Enable or AGS= Enable w/QT. Refer to
Figure 8-2.
• ME-ARC and ME-RTR – go to the CTRL: 03 Gen Control menu and
select OFF.
Note: After the fault clears and the reason for the fault is determined,
be sure to re-enable the AGS to autostart. Go to the CTRL: 03 Gen Con-
trol menu and select AUTO. Refer to Figure 9-2 for the ME-ARC, and to
Figure 10-2 for the ME-RTR.
Once the fault is cleared and the reason for the fault is determined, you
should re-enable the AGS to see if the fault returns, or test the AGS/genera-
tor system by performing the AGS Functional Test for your remote (see Sec-
tion 8.2 for a ME-RC; Section 9.2 for a ME-ARC; Section 10.2 for a ME-RTR).