Magnum Energy AGS Network (ME-AGS-N) - Manual (Page 100)

13.0 Appendix
© 2012 Magnum Energy, Inc. 94
13.0 Appendix
13.1 Other Accessories and Equipment
Magnum offers a number of devices and accessories that can be used to
expand and enhance your AGS and inverter/charger system.
13.1.1 Optional Accessories for the ME-AGS-N
AGS Pigtail Adapters
Magnum offers two pigtail adapters for use with the AGS. They are
useful
in applications that require you to automatically turn the generator on/
off externally via a manually controlled switch, or from an automatically
controlled switching device (i.e., using the A/C’s thermostat controls to turn
on the generator in order to run the A/C unit, or a relay control circuit):
• ME-PT1 (pigtail one-wire) adapter is designed to allow the AGS to start
the generator when an external +12-volt DC supply is applied.
• ME-PT2 (pigtail 2-wire) adapter is designed to allow the AGS to start
the generator by an external two-contact switch.
13.1.2 Additional Magnum Equipment/Accessories
The following devices are also available from Magnum Energy:
Battery Monitor
The Battery Monitor Kit (ME-BMK) is a single battery bank amp-hour meter
that monitors the condition of the battery and provides information to let you
know how much energy you have available. It also enables you to plan your
electrical usage to ensure the battery is not being over-discharged.
MagWeb (device monitoring thru the internet)
The ME-MW-W (MagWeb Wireless) and the ME-MW-E (MagWeb Wired Ether-
net) are tools for remotely monitoring Magnum inverters and accessories. The
ME-MW-W connects to the Magnum network via a wireless data link and the
ME-MW-E connects to the Magnum network via a wired Ethernet data link.
They both provide live internet monitoring of the inverter, battery monitor,
and the AGS. Using an “always on” internet connection, the MagWeb system
makes live and historical conditions available using a web browser and Mag-
num’s data transfer service.
MMP Series Enclosures
The MMP175-30D, MMP175-60S, MMP250-30D, and MMP250-60S enclosures
are for single inverter applications. The MMP Series enclosures have been
specifically designed to combine all of the major components required for
a renewable energy system — inverter/battery disconnect, AC overcurrent
protection, grounding connections and a full system inverter bypass switch
as a convenient way to isolate the inverter for battery maintenance — into a
single, easy to install pre-wired enclosure.
MP Series Enclosures
The MPSL, MPSH, MPDH enclosures have been specifically designed to combine
MS-PAE inverters when configured for parallel operation. The MP enclosures
feature convenient front-mounted AC and DC connections and easy panel
operation using the optional ME-RTR router. Choose the MP model based on
your power capacity needs. Each model is expandable. Start with the base
model and just one inverter, and in the future add another inverter — up to four
inverters total depending on your model — using the MPX expansion boxes.