Magnum Energy AGS Network (ME-AGS-N) - Manual (Page 45)

39 © 2012 Magnum Energy, Inc.
9.0 Using the ME-ARC Remote
9.0 Using the ME-ARC Remote
The ME-ARC remote control’s AGS menus under the CTRL, METER, SETUP,
and TECH buttons allow you to customize and monitor operating parameters,
and to help troubleshoot your autostart/autostop generator system. To help
confi gure and use the AGS with the ME-ARC, refer to the mini index below to
direct you to the appropriate section.
9.1 ME-AGS-N Setup using the ME-ARC page 39
9.2 ME-AGS-N Functional Tests using the ME-ARC page 52
9.3 ME-AGS-N Operation/Monitoring using the ME-ARC page 53
9.4 Enabling the ME-AGS-N using the ME-ARC page 56
9.5 Starting and Stopping the Generator using the ME-ARC page 56
9.6 ME-AGS-N Menu Map using the ME-ARC
page 58
Inverting
DC 12.6V 5A
FAVS CTRL METER SETUP TECH
CTRL, METER, SETUP and TECH Buttons
Status...
04 AGS Setup
Figure 9-1, ME-ARC’s AGS Configuration Access Buttons
This AGS manual covers ME-ARC remote controls with a revision of 2.0 to
2.4. There may be differences between revisions that affect your AGS setup/
operation. Use Table 9-2 to familiarize yourself with the differences between
AGS revisions.
Info: Refer to your ME-ARC owner’s manual to determine your re-
mote’s revision (or see the TECH: 02 Revisions – AGS menu section
on page 56).
9.1 ME-AGS-N Setup using the ME-ARC
Press the SETUP button on the ME-ARC remote, and then rotate the SELECT
knob to the 04 AGS Setup display. The menus available from this screen al-
low the generator to be automatically started and stopped based on many
different conditions. From Table 9-1, determine the specifi c autostart and
autostop conditions with which you want the generator to be automatically
controlled, and then use that specifi c menu setting to confi gure the AGS.
Info: For information on using the CTRL, METER, and TECH button
menus, refer to Section 9.3 “ME-AGS-N Operation/Monitoring using
the ME-ARC”.