Magnum Energy AGS Network (ME-AGS-N) - Manual (Page 93)

87 © 2012 Magnum Energy, Inc.
11.0 ME-AGS-N Remote Status Messages
11.3 AGS Remote Fault Statuses
The following “Fault” statuses indicate that the generator wasn’t able to start
based on an expected autostart condition. Refer to Section 12.3 “ME-AGS-N
Faults using your Remote” for help in diagnosing the problem.
Table 11-3, AGS Remote Fault Statuses
STATUS REMOTE DESCRIPTION
Gen Run
Fault
ARC/RTR The generator successfully started and ran
for more than two minutes, but unexpectedly
stopped before the AGS could automatically stop
the generator.
Fault
Amp
ARC/RTR The generator failed to start in Start Amps mode.
Fault
Exercise
ARC/RTR The generator failed to start in Start Exercise
mode.
Fault
MaxRn
ARC/RTR The generator turned off because the SETUP: 04F
Max Gen Run Time setting had been met. This
fault can occur when: 1) an autostop parameter
has been met, but it did not stop the generator,
or, 2) the autostop condition exceeded the Max
Gen Run Time setting.
Fault SOC ARC/RTR The generator failed to start in Start SOC mode.
Fault
Temp
RC/ARC/
RTR
The generator failed to start in Start Temp mode.
Fault Test RC/ARC/
RTR
The generator failed to start in Test mode.
Fault
Time
ARC/RTR The generator failed to start in Start Time mode.
Fault
Topoff
ARC/RTR The generator failed to start in Start Topoff mode.
Fault VDC RC/ARC/
RTR
The generator failed to start in Start VDC mode.