Yaskawa MP3200 Troubleshooting Manual - Manual (Page 87)

5.2 Troubleshooting Message Communications
5-12
No
Yes
No
Yes
B1 B2
From the
previous page
Is WAIT displayed in the
Transmission Status Box?
Is the local station the master
station (the MSG-SND
function is used)?
Check the following.
• Does the remote device exist and
is the power to the remote device
turned ON?
• Was the data saved to flash
memory and the power supply
turned OFF and ON again after
setting the parameters?
Check the processing
results and the status of
the message send
function.
Check the processing
results and the status of
the message receive
function.
Check other items.
END
Checking Message Functions
(MSG-SNDE and MSG-RCVE)
(page 5-20)
Checking Message Functions
(MSG-SNDE and MSG-RCVE)
(page 5-20)
Other Problems during Message Communications (page 5-38)