Yaskawa J7 Drive - Manual (Page 85)

A1-4
Table A1-1. J7 Parameters - Continued
PARAM- SETTING RANGE SETTING FACTORY USER PARA.
ETER NAME (AND UNITS) INCREMENT SETTING SETTING REF.
0: 2400 bps
n71 Modbus Baud Rate
1: 4800 bps
2: 9600 bps
1 2
3: 19200 bps 5.14
0: even parity
n72 Modbus Parity Selection 1: odd parity 1 2
2: no parity
n73 Modbus Send Waiting Time 10 to 65 1 (msec) 10
0: RTS control enabled
n74 Modbus RTS control 1: RTS control disabled 1 0
(RS-422A 1 to 1 communication)
n75 Reduce Carrier
0: Disabled
at low speed selection
1: Carrier Frequency reduced to 2.5kHz 1 0
when Fout <= 5Hz & Iout >= 110%
rdy : READY status rdy
rEd: READ executes rEd
n76
Digital Operator Parameter Cpy: COPY executes Cpy
rdy
Copy Function Selection vFy: VERIFY executes vFy
vA: Inverter capacity display vA
Sno: Software No. display Sno
n77
Digital Operator
0: Copying disabled
Parameter Copy
1: Copying allowed
1 0
Access Selection
n78 Fault History Note 2 N/A N/A
n79 Software Number Note 2 013
Note 1: Factory setting differs depending on capacity. See Appendix 3-1.
Note 2: n78 and n79 are display only parameters, which are not settable.