HEIDENHAIN SW 54843x-03 - Manual (Page 97)

HEIDENHAIN MANUALplus 620 97
3.5 Mac
h
ine set
u
p Defining offsets
Before using zero point shifts with G53, G54 and G55, you need to
define the offset values in setup mode.
Select Setting up
Select Set axis values
Press the Shift soft key
Enter the offset value
Press the G53 soft key
Press the G54 soft key
Press the G55 soft key
Press the Save soft key.
The MANUALplus saves the values to a table. In this way, you can
activate the offsets in the program by entering the respective G codes.
SET OFFSET