HEIDENHAIN SW 54843x-03 - Manual (Page 478)

478 ICP programming
5.15 Cont
ours in the YZ plane
Circular pattern in YZ plane
You can find the reference diameter XR with the "select reference
plane" function (siehe Seite 427).
ICP generates:
 The LATERAL_Y section code with the parameters reference
diameter and spindle angle. The section code is omitted for nested
contours.
 A G308 with the parameters contour name and milling depth or hole
depth (–1*BT).
 A G482 with the parameters of the pattern.
 The G function and the parameters of the figure/hole.
 A G309.
Reference data in YZ plane
ID
Contour name
PT Milling depth
C Spindle angle
XR Reference diameter
Parameters of pattern
Y, Z
Center of pattern
QP Number of points in pattern
DR Direction of rotation (default: 0)
 DR=0, without EP: Figures are arranged on a full circle
 DR=0, with EP: Figures are arranged on the longer
circular arc
 DR=0, with EPi: The algebraic sign of EPi defines the
direction (EPi<0: clockwise)
 DR=1, with EP: clockwise
 DR=1, with EPi: clockwise (algebraic sign of EPi has
no effect)
 DR=2, with EP: counterclockwise
 DR=2, with EPi: counterclockwise (algebraic sign of
EPi has no effect)
DP Pattern diameter
AP Starting angle (default: 0°)
EP End angle (no entry: the pattern elements are equally
divided into 360°)
EPi Angle between two figures
H Element position
 0: Normal position—the figures are rotated about the
circle center (rotation)
 1: Original position—the position of the figures
relative to the coordinate system remains unchanged
(translation)
Parameters of the selected figure/hole