HEIDENHAIN SW 54843x-03 - Manual (Page 638)

638 Tables and overviews
9.4 Compatibility in DIN pr
ogr
a
ms
Contour-based turning cycles G810 Longitudinal roughing cycle þ
G820 Face roughing cycle þ
G830 Contour-parallel roughing cycle þ
G835 Contour-parallel with neutral tool þ
G860 Universal recessing cycle þ
G866 Simple recessing cycle þ
G869 Recess turning cycle þ
G890 Finishing cycle þ
Thread cycles G31 Thread cycle þ
G32 Single thread cycle þ
G33 Single thread cut (Thread single path) þ
G933 Thread switch –
G799 Thread milling, axial þ
G800 Thread milling in XY plane þ
G806 Thread milling in YZ plane þ
Synchronization commands
Assigning contour to operation G98 Assignment of spindle to workpiece –
G99 Workpiece group 
Slide synchronization G62 One-sided synchronization 
G63 Synchronous start of slides 
G162 Synchronization marking 
Contour follow-up G702 Storing/loading contour follow-up þ
G703 Contour follow-up ON/OFF þ
G706 K default branch –
Cycles for turning