HEIDENHAIN SW 54843x-03 - Manual (Page 262)

262 Cycle programming
4.5 Recessing cy
cles
ICP recess turning, axial finishing
Call the recessing cycles
Select recess turning
Select recess turning, axial ICP
Press the Finishing run soft key
The cycle finishes the contour area defined by the ICP contour (see
also “Recess turning” auf Seite 240). At the end of the cycle, the tool
returns to the starting point.
With oversizes I, K for the workpiece blank, you define
the material to be machined during the finishing cycle. For
this purpose, enter the oversizes for recess turning,
finishing.
With oversizes I, K, you define the material left
remaining after the finishing cycle.
Cycle parameters
X, Z
Starting point
FK ICP finished part: Name of the contour to be machined
RB Depth compensation
I, K Oversize X, Z
RI, RK Workpiece blank oversizes in X and Z
SX, SZ Cutting limits (siehe Seite 142)
G14 Tool change point (siehe Seite 142)
A Starting angle defines the machining area at the contour
starting point
W End angle defines the machining area at the contour end
point
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
G47 Safety clearance (siehe Seite 142)
MT M after T: M function that is executed after the tool call T.