HEIDENHAIN SW 54843x-03 - Manual (Page 436)

436 ICP programming
5.12 F
a
ce cont
ours in smar
t.T
u
rn
Circular pattern on face
You can find the reference dimension ZR with the "select reference
plane" function (siehe Seite 427).
ICP generates:
 The FACE_C section code with the reference dimension parameter.
In nested contours, ICP generates only one section code.
 A G308 with the parameters contour name and milling depth or hole
depth (–1*BT).
 A G402 with the parameters of the pattern.
 The G function and the parameters of the figure/hole.
 A G309.
Reference data of face
ID
Contour name
PT Milling depth
ZR Reference dimension
Parameters of pattern
XK, YK
Center of pattern (Cartesian coordinates)
QP Number of points in pattern
DR Direction of rotation (default: 0)
 DR=0, without EP: Figures are arranged on a full circle
 DR=0, with EP: Figures are arranged on the longer
circular arc
 DR=0, with EPi: The algebraic sign of EPi defines the
direction (EPi<0: clockwise)
 DR=1, with EP: clockwise
 DR=1, with EPi: clockwise (algebraic sign of EPi has
no effect)
 DR=2, with EP: counterclockwise
 DR=2, with EPi: counterclockwise (algebraic sign of
EPi has no effect)
DP Pattern diameter
AP Starting angle (default: 0°)
EP End angle (no entry: the pattern elements are equally
divided into 360°)
EPi Angle between two figures
H Element position
 0: Normal position—the figures are rotated about the
circle center (rotation)
 1: Original position—the position of the figures
relative to the coordinate system remains unchanged
(translation)
Parameters of the selected figure/hole