HEIDENHAIN SW 54843x-03 - Manual (Page 538)

538 Tool and technology database
7.
4 T
e
c
hnolog
y database
7.4 Technology database
The technology database manages the cutting data according to the
machining mode, the workpiece material and the cutting material. The
graphic on this page shows the composition of the database. Each
cube represents a data record with cutting data.
In its standard version, the technology database is designed for 9
workpiece-material/tool-material combinations. You can optionally
expand the database to 62 workpiece material-cutting material
combinations.
The MANUALplus ascertains these criteria from the following
information:
 Machining operation: A machining operation is assigned in the
cycle programming (Teach-in mode) to each cycle, and in smart.Turn
to each unit (see table).
 Work material: The workpiece material is defined in the TSF menu
during cycle programming, and in the program header in smart.Turn.
 Cutting material: Each tool description contains the cutting
material.
Using these three criteria, the MANUALplus accesses the cutting data
record (shown yellow in the figure) and generates from it the
technology-data proposal.
Explanation of abbreviations used in the graphic:
 Task: Machining operation
 WS: Workpiece material
 SS: Cutting material
Types of machining
Predrilling Not used
Roughing 2
Finishing 3
Thread cutting 4
Contour recessing 5
Parting 6
Centering 9
Drilling 8
Countersinking 9
Reaming Not used
Tapping 11
Milling 12
Finish milling 13
Deburring 14
Engraving 15
Recess turning 16