HEIDENHAIN SW 54843x-03 - Manual (Page 294)

294 Cycle programming
4.6 Thr
ead and under
c
ut cy
cles
Type of machining for technology database access: Finishing
All parameters that you enter will be accounted for—even if the
standard table prescribes other values. If the parameters I, K, W and
R are not defined, the MANUALplus determines these parameters
from "FP" in the standard table (see “DIN 76—undercut parameters”
auf Seite 617).
Cycle run
1 Approach workpiece from starting point
 to the cylinder starting point X1, or
 for the thread chamfer
2 Machine thread chamfer, if defined
3 Finish cylinder up to beginning of undercut
4 Pre-machine undercut, if defined
5 Machine undercut
6 Finish to end point X2 on plane surface
7 Return
 Without return: the tool remains at end point on plane
surface
 With return: Retract and return diagonally back to starting point
8 Move to the tool change point according to the G14 setting
B Cylinder start chamfer (default: no start chamfer)
WB First-cut angle (default: 45 °)
RB First-cut radius (default: no input = no element): Positive
value = first-cut radius, negative value = chamfer
G47 Safety clearance (siehe Seite 142)—evaluated only if "With
return" is active
MT M after T: M function that is executed after the tool call T.
MFS M at beginning: M function that is executed at the
beginning of the machining step.
MFE M at end: M function that is executed at the end of the
machining step.
WP Displays which workpiece spindle is used to process the
cycle (machine-dependent)
 Main drive
 Opposing spindle for rear-face machining