HEIDENHAIN SW 54843x-03 - Manual (Page 81)

HEIDENHAIN MANUALplus 620 81
3.3 Mac
h
ine data
TSF dialog box with input of all cutting data
Select Set T, S, F (only available in Manual mode)
Define the parameters
Conclude data input
TSF dialog box with separate dialogs
Select Set T, S, F (only available in Manual mode)
Select T for tool change
Select S for setting the spindle speed
Select F for setting the feed rate
Enter the parameters in the submenu
Conclude data input
Soft keys for "Set T, S, F"
Siehe „Tool compensation” auf
Seite 110.
Siehe „Touch off” auf Seite 107.
Call the tool list. Transfer of T number
from the tool list: Siehe „Setting up a tool
list” auf Seite 88.
Transfer of cutting speed and feed rate
from the technology data.
 On: Feed per minute (mm/min)
 Off: Feed per revolution (mm/rev)
 On: Constant speed (rpm)
 Off: Constant surface speed (m/min)
ENTER THE TOOL DATA AND TECHNOLOGY DATA
Caution. Depending on the machine, this operation might
cause the turret to turn.
ENTER THE TOOL DATA OR TECHNOLOGY DATA
Caution. Depending on the machine, the input of data in
the T dialog might cause the turret to turn.