HEIDENHAIN SW 54843x-03 - Manual (Page 85)

HEIDENHAIN MANUALplus 620 85
3.3 Mac
h
ine data
Spindle display with spindle number, gear range and spindle status
 Upper field: Programmed speed
 Lower field: Actual speed or spindle position
Spindle display with spindle number, gear range and spindle status
 Upper field: Setting of the override control
 Middle field: Programmed speed
 Lower field: Actual speed or spindle position
Override display of the active spindle
 F: Feed rate
 R: Rapid traverse
 S: Spindle
Utilization of the drives: Utilization of the drive relative to the rated torque.
 Digital axis and spindle motors
 Analog axis and spindle motors, if set up by the machine tool builder
Display of unit quantities: The quantity is incremented after each M30, M99 or
M18 programmed counter pulse.
 MP: Default unit quantity
 P: Number of finished parts
Display of unit quantities and time per unit: The quantity is incremented after
each M30, M99 or M18 programmed counter pulse.
 MP: Default unit quantity
 P: Number of finished parts
 t: Run time of the current program
 Sum t: Total time
Display of skip levels and M01 conditional stop
 Defined skip levels (upper row) and set/activated skip levels (lower row)
 Setting for M01: M01 is not executed in Continuous Run mode (yellow display)
Display of rear-face machining: The RSM display (RSM: Rear Side Machining)
provides information about rear-face machining.
 RSM status
 Active zero point shift of the configured RSM axis
Elements of machine data display