HEIDENHAIN SW 54843x-03 - Manual (Page 258)

258 Cycle programming
4.5 Recessing cy
cles
ICP recess turning, axial
Call the recessing cycles
Select recess turning
Select recess turning, axial
The cycle clears the defined area (see also “Recess turning” auf
Seite 240).
If you are machining
 descending contours, define only the starting
point
—not the contour starting point. The cycle
clears the area defined by the starting point and the ICP
contour, taking the oversizes into account.
 inclining contours, define the starting point and the
contour starting point.
The cycle clears the area
defined by the contour starting point and the ICP
contour, taking the oversizes into account.
Cycle parameters
X, Z
Starting point
X1, Z1 Starting point of blank
FK ICP finished part: Name of the contour to be machined
P Infeed depth: Maximum infeed depth
ET Recessing depth by which one cut is fed.
O Recessing feed rate (default: active feed rate)
I, K Oversize X, Z
SX, SZ Cutting limits (siehe Seite 142)
B Offset width (default: 0)
U Unidirectional turning (default: 0)
 0: Bidirectional
 1: Unidirectional (direction: see help graphic)
G14 Tool change point (siehe Seite 142)
A Starting angle defines the machining area at the contour
starting point
W End angle defines the machining area at the contour end
point