HEIDENHAIN SW 54843x-03 - Manual (Page 198)

198 Cycle programming
4.4 T
u
rn
ing cy
cles
Cut, ICP contour-parallel, longitudinal finishing
Select cut, longitudinal/transverse
Select ICP contour-parallel, longitudinal
Press the Finishing run soft key
The cycle finishes the contour area defined by the ICP contour. When
the cycle is completed, the tool remains at the cycle end position.
The tool plunges with the maximum possible angle,
leaving material remaining.
Cycle parameters
X, Z
Starting point
FK ICP finished part: Name of the contour to be machined
DXX Additive compensation number: 1-16 (siehe Seite 142)
G58 Contour-parallel oversize
DI Axis-parallel oversize X
DK Axis-parallel oversize Z
SX, SZ Cutting limits (siehe Seite 142)
G47 Safety clearance (siehe Seite 142)
G14 Tool change point (siehe Seite 142)
T Turret pocket number
ID Tool ID number
S Spindle speed/cutting speed
F Feed per revolution
MT M after T: M function that is executed after the tool call T.