HEIDENHAIN SW 54843x-03 - Manual (Page 549)

HEIDENHAIN MANUALplus 620 549
8.2 P
a
ra
met
e
rs
... / Tool measurement (604600)
Measuring feed rate [mm/min] (604602) Feed rate for approaching the touch probe
Measuring range [mm] (604603) The touch probe must be triggered within the
measuring range. Otherwise, an error message is
issued.
... / Settings for Machine operating mode (604900) / ...
.../ Save cycle without simulation (604903)
TRUE Cycle can be saved without previous simulation or
execution.
FALSE Cycle can only be saved after previous simulation or
execution.
.../ Run a tool change with NC start (604904)
TRUE The tool change with the TSF dialog is conducted with
Cycle Start.
FALSE The tool change is not conducted with Cycle Start.
.../ Separate dialogs for tool change, speed and feed rate
(604906)
TRUE Data input for tool change, spindle speed and feed rate
in separate dialogs
FALSE TSF dialog box with input of all cutting data
... / Settings for load monitoring (124700) / ...
.../ Activate load monitoring (124701)
TRUE Load monitoring is active
FALSE Load monitoring is inactive
.../ Factor for utilization limit 1 [%] (124702) This value multiplied by the reference value
determined by reference machining results in the
utilization limit value 1.
.../ Factor for utilization limit 2 [%] (124703) This value multiplied by the reference value
determined by reference machining results in the
utilization limit value 2.
.../ Factor for total utilization limit [%] (124704) This value multiplied by the reference value
determined by reference machining results in the total
utilization limit value.
Parameters: System / ... Meaning