HEIDENHAIN SW 54843x-03 - Manual (Page 408)

408 ICP programming
5.8 Cont
our elements of a t
u
rn
ing cont
our
Thread undercut DIN 76
Select the form elements.
Select Undercut DIN 76.
Enter the undercut parameters.
In smart.Turn, ICP generates a G25.
The MANUALplus calculates unentered parameters automatically
from the standard table (see “DIN 76—undercut parameters” auf
Seite 617):
 The "thread pitch FP" is determined from the diameter.
 The parameters I, K, W, and R are calculated from the thread pitch
FP.
Parameters
FP
Thread pitch (default: value from standard table)
I Undercut depth (radius) (default: value from standard
table)
K Undercut length (default: value from standard table)
R Undercut radius (default: value from standard table)
W Undercut angle (default: value from standard table)
U, F, D, FP: See machining attributes on Seite 377
 If you are programming an internal thread, it is advisable
to preset the thread pitch FP, since the diameter of the
longitudinal element is not the thread diameter. If you
have the MANUALplus calculate the thread pitch
automatically, slight deviations may occur.
 Undercuts can be programmed only between two linear
elements. One of the two linear elements must be
parallel to the X axis.