HEIDENHAIN SW 54843x-03 - Manual (Page 560)

560 Organization mode of operation
8.2 P
a
ra
met
e
rs
... / Measurement oversize (MA) (602605) Oversize on the element to be measured
... / Measuring cut length (MSL) (602606) Measuring cut length
... / Drilling (602700) / ...
... / Approach/front face – drilling (ANBS) (602701) Approach strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Appr./lateral surface – drilling (ANBM) (602702) Approach strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Dep./front face – drilling (ABBS) (602703) Departure strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Dep./lateral surface – drilling (ABBM) (602704) Departure strategy:
 1: Move simultaneously in X and Z directions
 2: First X, then Z direction
 3: First Z, then X direction
 6: Coupled motion; X precedes Z direction
 7: Coupled motion; Z precedes X direction
... / Internal safety clearance (SIBC) [mm] (602705) Retraction distance for deep-hole drilling "B"
... / Driven drill (SBC) (602706) Safety clearance for driven tools
... / Stationary drill (SBCF) (602707) Safety clearance for tools that are not driven
... / Driven tap (SGC) (602708) Safety clearance for driven tools
... / Stationary tap (SGCF) (602709) Safety clearance for tools that are not driven
... / Drilling depth factor (BTCF) (602710) Factor for calculation of the first drilling depth for deep-
hole drilling
... / Depth reduction (BTRC) [mm] (602711) Reduction for deep-hole drilling
Parameters: Processing / ... Meaning