HEIDENHAIN SW 54843x-03 - Manual (Page 413)

HEIDENHAIN MANUALplus 620 413
5.8 Cont
our elements of a t
u
rn
ing cont
our
Undercut type K
Select the form elements.
Select the undercut type K.
Enter the undercut parameters.
In smart.Turn, ICP generates a G25.
Parameters
I
Undercut depth
R Undercut radius
W Angular length
A Plunge angle
U, F, D, FP: See machining attributes on Seite 377
Undercuts can be programmed only between two linear
elements. One of the two linear elements must be parallel
to the X axis.