HEIDENHAIN SW 54843x-03 - Manual (Page 637)

HEIDENHAIN MANUALplus 620 637
9.4 Compatibility in DIN pr
ogr
a
ms
Safety clearances G47 Set safety clearances þ
G147 Safety clearance (milling cycles) þ
Tools, types of compensation T Tool call þ
G148 Switching the tool edge compensation þ
G149 Additive compensation þ
G150 Compensation of right-hand tool tip þ
G151 Compensation of left-hand tool tip þ
G710 Adding tool dimensions 
Cycles for turning
Simple turning cycles G80 End of cycle þ
G81 Simple longitudinal roughing þ
G82 Simple face roughing þ
G83 Simple contour repeat cycle þ
G85 Undercut þ
G86 Simple recessing cycle þ
G87 Transition radii þ
G88 Chamfers þ
Drilling cycles G36 Tapping þ
G71 Simple drilling cycle þ
G72 Counterboring, countersinking, etc. þ
G73 Tapping cycle þ
G74 Deep hole drilling cycle þ
G commands for machining