HEIDENHAIN SW 54843x-03 - Manual (Page 330)

330 Cycle programming
4.8 Milling cy
cles
Face milling
Select milling
Select the "Face milling" cycle
Depending on the parameters, the cycle mills the following contours
on the face.
 One or two surfaces (Q=1 or Q=2, B>0)
 Rectangle (Q=4, L<>B)
 Square (Q=4, L=B)
 Triangle or polygon (Q=3 oder Q>4, L<>0)
 Circle (Q=0, RE>0, L and B: No input)
Cycle parameters (first input window)
X, Z
Starting point
C Spindle angle (C-axis position)
X1 Diameter of figure center
C1 Angle of figure center (default: spindle angle C)
Z1 Milling top edge (default: starting point Z)
Z2 Milling floor
Q Number of edges
 Q=0: Circle
 Q=1: One surface
 Q=2: Two surfaces offset by 180°
 Q=3: Triangle
 Q=4: Rectangle, square
 Q>4: Polygon
L Edge length
 Rectangle: Rectangle length
 Square, polygon: Edge length
 Polygon: L<0: Inscribed circle diameter
 Circle: No input
B Width across flats:
 For Q=1, Q=2: Remaining thickness (remaining
material)
 Rectangle: Rectangle width
 Square, polygon (Q>=4): Width across flats (use only for
even number of surfaces; program "B" as an alternative
to "L")
 Circle: No input