HEIDENHAIN SW 54843x-03 - Manual (Page 475)

HEIDENHAIN MANUALplus 620 475
5.15 Cont
ours in the YZ plane
Circular slot in YZ plane
You can find the reference diameter XR with the "select reference
plane" function (siehe Seite 427).
ICP generates:
 The LATERAL_Y section code with the parameters reference
diameter and spindle angle. The section code is omitted for nested
contours.
 A G308 with the parameters contour name and milling depth.
 A G382 or G383 with the parameters of the figure.
 A G309.
Reference data in YZ plane
ID
Contour name
PT Milling depth
C Spindle angle
XR Reference diameter
Parameters of figure
YM, ZM
Figure center
A Starting angle (reference: X axis)
W End angle (reference: X axis)
R Curvature radius (reference: center point path of the
slot)
Q2 Direction of rotation
 CW
 CCW
B Width