HEIDENHAIN SW 54843x-03 - Manual (Page 21)

HEIDENHAIN MANUALplus 620 21
3.1 Machine mode of operation ..... 76
3.2 Switch-on / Switch-off ..... 77
Switch-on ..... 77
Monitoring EnDat encoders ..... 77
Traversing the reference marks ..... 78
Switch-off ..... 79
3.3 Machine data ..... 80
Input of machine data ..... 80
Machine data display ..... 82
Cycle statuses ..... 86
Axis feed rate ..... 86
Spindle ..... 87
3.4 Setting up a tool list ..... 88
Machine with turret ..... 88
Machine with multifix ..... 88
Tools in different quadrants ..... 89
Filling the turret list from the database ..... 90
Filling the turret list ..... 91
Tool call ..... 92
Driven tools ..... 92
Tool life monitoring ..... 93
3.5 Machine setup ..... 95
Defining the workpiece zero point ..... 96
Defining offsets ..... 97
Homing the axes ..... 98
Setting the protection zone ..... 99
Defining the tool change position ..... 100
Setting C-axis values ..... 101
Setting up machine dimensions ..... 102
Calibrating the tool touch probe ..... 103
Displaying operating times ..... 104
Setting the system time ..... 105
3.6 Tool measurement ..... 106
Touch off ..... 107
Touch probe (tool touch probe) ..... 108
Optical gauge ..... 109
Tool compensation ..... 110
3.7 Manual mode ..... 111
Tool change ..... 111
Spindle ..... 111
Handwheel operation ..... 111
Manual direction keys ..... 112
Teach-in cycles in Manual mode ..... 112
3 Machine mode of operation ..... 75