HEIDENHAIN SW 54843x-03 - Manual (Page 430)

430 ICP programming
5.12 F
a
ce cont
ours in smar
t.T
u
rn
TURN PLUS attributes
In the TURN PLUS attributes you can define settings for the automatic
program generation (AWG).
Circle on face
You can find the reference dimension ZR with the "select reference
plane" function (siehe Seite 427).
ICP generates:
 The FACE_C section code with the reference dimension parameter.
In nested contours, ICP generates only one section code.
 A G308 with the parameters contour name and milling depth.
 A G304 with the parameters of the figure.
 A G309.
Parameters for defining the starting point
HC
Milling/drilling attribute:
 1: Contour milling
 2: Pocket milling
 3: Area milling
 4: Deburring
 5: Engraving
 6: Contour milling and deburring
 7: Pocket milling and deburring
 14: Do not machine
QF Milling location:
 0: On the contour
 1: Inside/left
 2: Outside/right
HF Direction:
 0: Up-cut milling
 1: Climb milling
DF Cutter diameter
WF Angle of the chamfer
BR Chamfer width
RB Retraction plane
Reference data of face
ID
Contour name
PT Milling depth
ZR Reference dimension
Parameters of figure
XKM, YKM Center of figure (Cartesian coordinates)
R
Radius