HEIDENHAIN SW 54843x-03 - Manual (Page 86)

86 Machine mode of operation
3.3 Mac
h
ine data
Cycle statuses
The MANUALplus shows the current cycle status with the cycle
symbol (see table at right).
Axis feed rate
F is the identification letter for feed data. Depending on which mode
of the Feed rate soft key is active, data is entered in:
 Millimeters per spindle revolution (feed per revolution)
 Millimeters per minute (feed per minute).
On the screen, you can tell the type of feed rate from the unit of
measure in the input field.
You can change the feed value with the feed compensation
controller (feed override) (range: 0 % to 150 %).
B-axis display: The information displayed about the status of the tilted plane varies
depending on the setting of the machine parameters.
 Programmed angular value of the B axis
 Display of the current values I, K, U and W
 I: Plane reference in X
 K: Plane reference in Z
 U: Shift in X
 W: Shift in Z
Elements of machine data display
The machine data display is configurable by the machine
tool builder. The machine data that appear on your screen
may therefore deviate from the example shown.
Cycle symbols
Status "Cycle ON"
Cycle or program execution is active.
Status "Cycle OFF"
Cycle or program execution is not active.