Grass Valley Aurora Browse v.7.0 Installation - Manual (Page 63)

April 6, 2010 Aurora Browse Installation and Configuration Guide 63
Setting deployment options
The recommended deployment group distribution is as follows.
Depending on your system design, your system might not have all
the device types listed.
In a deployment group named "Aurora_Edit_Ingest_Playout", place the following
devices:
• Aurora Edit workstation of any storage options: Shared storage, NAS storage, and
stand-alone.
• Aurora Edit LD computer
• DSM
• Conform Server
• SmartBin Server
• FTP Server
• Aurora Ingest workstation
• IEP
• Aurora Playout computer
In a deployment group named "Aurora_Browse_MediaFrame", place the following
devices:
• MediaFrame server
• MDI server
• Aurora Proxy Encoder
• K2 BaseCamp Express
If you have a K2 Nearline SAN (NAS), in a deployment group named for the SAN
system, place the following devices:
• The Nearline SAN's K2 Media Servers.
Setting deployment options
Pre-requisites for this procedure are as follows:
• A software package has been assigned to the deployment group and applicable
deployment tasks are now displayed in the Tasks area.
1. In the Software Deployment | Deployment Groups tree view, select a deployment
group.
2. In the Tasks list view, view tasks and determine if you must set deployment
options. Tasks that need to have deployment options set display in the Details
column a message stating “Deployment options required.”
If you select a tasks that needs to have its deployment options set, the Start
Deployment button is disabled and the message is displayed next to the button.
3. Proceed with next steps to set deployment options for the following: