Grass Valley Aurora Browse v.7.0 Installation - Manual (Page 156)

156 Aurora Browse Installation and Configuration Guide April 6, 2010
Chapter 6 Database and Recovery Planning
shutting down.
Restoring from a system-specific recovery disk image on E:
The following procedure can be used on a MediaFrame server that needs its image
restored, if the image was made from that specific machine. If the image is the generic
factory-default image, refer to the next procedure
“Restoring from the generic
recovery disk image on E:”
1. Make sure that media access is stopped and that the MediaFrame server on which
you are working is out of service.
2. If you have not already done so, connect keyboard, monitor, and mouse to the
MediaFrame server.
3. Insert the Recovery CD and restart the machine. If there is a problem restarting,
hold the standby button down for five seconds to force a hard shutdown. Then press
the standby button again to startup.
The machine boots from the disc. The Acronis True Image program loads.
4. At the startup screen, select True Image Server (Full Version) .
The Acronis True Image program loads.
The Acronis True Image main window appears.
5. In the Acronis True Image main window, click Recovery .
The Restore Data Wizard opens.
6. On the Welcome page, click Next .
The Archive Selection page opens.
7. In the tree view expand the node for the E: partition and select the image file, then
click Next :
The Verify Archive Before the Restoring page opens.
8. Leave the selection at No, I don’t want to verify and then click Next .
The Partition or Disk to Restore page opens.
9. Select OS (C:) and then click Next .
The Restored Partition Location page opens.
10. Select OS (C:) and then click Next .
The Restored Partition Type page opens.
11. Leave the selection at Active and then click Next .
The Restored Partition Size page opens.
12. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual C: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next .
The Next Selection page opens.
13. Depending on the partitions you are restoring, do one of the following: