Grass Valley Aurora Browse v.7.0 Installation - Manual (Page 163)

April 6, 2010 Aurora Browse Installation and Configuration Guide 163
Activating the Windows operating system
Click Next .
The Restored Partition Sizing page opens.
11. Select No, I don’t want to resize source partitions and then click Next .
The Restored Hard Disk Drive Location page opens.
12. Select Disk 1 and then click Next .
The Non-Empty Destination Hard Disk Drive page opens.
13. Select Yes…delete all partitions… and then click Next .
If messages appear asking for disks, insert CDs sequentially and click Retry until
you can proceed to the next step.
The Next Selection page opens.
14. Select No, I do not and then click Next .
The Restore Operation option page opens.
15. Do not make any selections. Click Next .
The “…ready to proceed…” page opens.
16. Verify that you are restoring partitions. Click Proceed .
The Operation Progress page opens and displays progress.
17. Insert CDs as prompted. As messages appear asking for disks, insert CDs
sequentially and click Retry .
18. When a “The data was successfully restored” message appears, click OK .
19. Click Operations | Exit to exit the Acronis True Image program.
The MediaFrame server restarts automatically.
20. Remove the Recovery CD while the MediaFrame server is shutting down.
Activating the Windows operating system
If a MediaFrame server is restored to its factory default state or otherwise has the
Windows operating system re-applied, you might need to activate the operating
system. This procedure provides instructions for doing this while the machine is
connected to the Internet. The Activation wizard provides other options, which you
can also choose if desired.
To active the Windows operating system on a K2 device, do the following:
1. Make sure the machine is connected to the Internet.
2. From the Windows desktop, in the system tray double-click on the key symbol
icon. The Activate window opens.
3. Select Yes, let's activate Windows over the Internet now and click Next .
4. When prompted, “If you want to register with Microsoft right now.”, select No .
5. Wait for the connection. If the system times out, you are prompted for entering
information in the Internet Protocol Connection dialog. Enter the proxy address
and port number as appropriate for your facility’s connections.