Grass Valley Aurora Browse v.7.0 Installation User Manual
Page 157
April 6, 2010
Aurora Browse Installation and Configuration Guide
157
Restoring from the generic recovery disk image on E:
• If you are restoring only the C: partition, select
No, I do not
and then click
Next
.
The “…ready to proceed…” page opens.
Skip ahead to step 20.
• If you are also restoring the D: partition, select
Yes, I want to restore another
partition or hard disk drive
and then click
Next
.
The Partition or Disk to Restore page opens. Continue with the next step in this
procedure.
14. Select
Data (D:)
and then click
Next
.
The Restored Partition Location page opens.
15. Select
Data (D:)
and then click
Next
.
The Restored Partition Type page opens.
16. Leave the selection at
Primary
and then click
Next
.
The Restored Partition Size page opens.
17. Leave settings at their defaults. The size reported in the upper pane is the size
detected of the actual D: partition. This should be the same as that reported in the
Partition size field in the middle of the page. Free space before and Free space after
should both be reported at 0 bytes. Click
Next
.
The Next Selection page opens.
18. Select
No, I do not
and then click
Next
.
The Restore Operation option page opens.
19. Do not make any selections. Click
Next
.
The “…ready to proceed…” page opens.
20. Verify that you are restoring the correct partition or partitions. Click
Proceed
.
The Operation Progress page opens and displays progress.
21. When a “The data was successfully restored” message appears, click
OK
.
22. Click
Operations | Exit
to exit the Acronis True Image program.
The MediaFrame server restarts automatically.
23. Remove any CD currently in the CD drive while the MediaFrame server is shutting
down.
24. If restoring a MediaFrame or K2 BaseCamp Express server, follow the procedure
described in
“Updating the maintenance plan after renaming the server” on
page 148
.
Restoring from the generic recovery disk image on E:
There can be multiple versions of the generic recovery disk image on the MediaFrame
server’s E: partition. Refer to Aurora Browse Release Notes to determine which
version you should use.