Grass Valley Aurora Browse v.7.0 Installation - Manual (Page 102)

102 Aurora Browse Installation and Configuration Guide April 6, 2010
Chapter 5 Configuring the system
8. The default value on the Asset System Dwell Time is 120 seconds.
9. Make sure the StandAlone radio button is checked.
10.Click Add as a managed device.
11.If adding an additional Profile MDI, increment the port number, e.g. enter 9131.
The following settings enable transfers. You should add all available transfer targets,
as specified in
“Configuring transfer targets” on page 87 .
12.Under Transfer Servers, click Add .
13.Use the drop-down list to specify the MDI name.
14.Enter the Transfer Server for the MDI selected above.
15.Use the drop-down list to specify the network type.
16.Leave the Public Address field blank.
17.To put changes into effect, start or restart the Profile MDI service on the MDI
Server.