Grass Valley Aurora Browse v.7.0 Installation - Manual (Page 177)

April 6, 2010 Aurora Browse Installation and Configuration Guide 177
Configuring the low-res storage on the K2 BaseCamp Express server
Configuring the low-res storage on the K2
BaseCamp Express server
The low-res storage is typically already configured before being shipped. If you need
to re-image your system, as described in
“Backup and recovery strategies” on
page 151 , then you will need to configure the low-res storage.
To configure the low-res storage, follow these steps:
1. If BaseCamp Express has been restored from the factory image, and all existing
partitions were removed, create a partition for all remaining unused disk space.
2. Create two shared folders: Media and Audio.
3. Configure the NTFS MDI, as described in “Configure NTFS MDI” on page 121 .
4. Prepare the NAS, as described in “Prepare NAS - Condor” on page 79 .
Upgrading K2 BaseCamp Express
You can add additional encoders to K2 BaseCamp Express. For more information, see
your Grass Valley support representative.