Visara FEP-4600 Installation - Manual (Page 85)

FEP-4600 Installation and Configuration
707119-001 7-1
Chapter 7. SDLC Interface
The SDLC interfaces should be configured after the ESCON interfaces are configured
and prior to configuration of the circuits.
SDLC interfaces are provided on the FEP-4600 through one or more QSA (Quad Serial
Adapters). To support SDLC attached platforms on the FEP-4600, it will be necessary to
customize the configuration. Configuration for SDLC is conducted in two parts. The first
part is to configure the common Line Options used by all platforms communicating over
a particular line. The second part is to configure the Drop Options. Each platform
communicating over the line will have a separate set of Drop Options.
To configure the SDLC interface, select ‘Configure’ from the menu at the top of most
panels, to display the Configuration menu as shown below.
Select ‘Connectivity’ to display the Connectivity Configuration menu as shown below.