Visara FEP-4600 Installation - Manual (Page 48)

Chapter 4. ESCON Interface
4-12 707119-001
Configuring Subchannels for Protocol ‘NSNA (3174, 2701)’
Pressing the ‘Subchannel’ button causes the following panel to display when the selected
protocol is NSNA.
This panel displays each of the subchannel addresses that are included in the address
range that was configured on the previous panel. You may modify the fields on this panel
and save the changes as needed.
The dropdown control located in the upper center portion of the panel allows you to
select and display other CUs defined for this ESCON interface.
Field Definitions
ID: This column displays the name assigned to each of the subchannels by the
administrator. These names can be most any text character string that you choose to use
(use alphanumeric characters as well as dash, underscore, and period), and should be
selected to describe the interface uniquely.
Enable Checkbox: This checkbox indicates whether this definition is to be considered
an active connection or not. If the checkbox is not checked, the definition will be ignored,
and the status panels will not reflect that the definition exists. (Green status will reflect
that all of the “enabled” interfaces are up as they should be.)