Super Systems 20PQ - Manual (Page 50)

46
CnF. 3
- Secondary control output in engineering unit
- [C.F13]
This parameter will be available only when secondary control
output is configured.
Range: nO
= Scalable is not required
YES = Scalable is required
NOTE: This scaling allows to display the output value in
engineering units instead of in percent.
- Secondary control output decimal point
position - [C.F14]
This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F13]) is set to "YES".
Range:
----.
= No decimal figure
---.-
= One decimal figure.
--.--
= Two decimal figures.
- Secondary control output initial scale value
- [C.F15]
This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F13]) is set to "YES".
Range: from -199 to 999
NOTE: The secondary control output initial scale value can be
higher than the secondary control output full scale value.
- Secondary control output full scale value
- [C.F16]
This parameter will be available only when "S.SCL" ("Secondary
control output in engineering units" [C.F13]) is set to "YES".
Range: From -199 to 999
XKP-1-C2.p65 10/30/01, 9:37 AM 46