Super Systems 20PQ - Manual (Page 31)

27
t+MENU= are used to start the lamp test function (see
paragraph "Lamp test")
s+FUNC or t+FUNC
During parameter modification they allow you to
increase/decrease the value under modification with
higher rate.
s+MAN or t+MAN
o During parameter modification they allow you to
jump to the max or min programmable value.
o When the instrument operates as programmer in
HOLD mode, they allow to jump to the beginning of
the next segment or to the end of the previous one.
NOTES:
1) All the actions explained above which require the pressure of
two or more push-buttons must follow exactly the push-button
sequence shown.
2) A 10 or 30 seconds time out (see "t.out" [C.I10]) can be
selected for parameter modification during run time mode.
If, during parameter modification, no push-button is
depressed for more than 10 (30) seconds, the instrument
goes automatically to the “normal display mode” and the
eventual modification of the last parameter will be lost.
CONFIGURATION MODE
Switch on the instrument.
The instrument will start in the same way it was prior to the
power down (configuration mode or run time mode)
If the instrument starts in configuration mode, push the MENU
pushbutton and go to the "Configuration group 1" (see page 31).
If the instrument starts in run time mode, by keeping depressed
the MENU push-button for more than 5 seconds the instrument
will show:
NOTES:
1) The upper display shows the selected parameter family.
2) The middle display shows the selected action.
3) The lower display shows the firmware version.
4) If no push-button is depressed for more than 10 s (or 30 s
according to "CnF.6" "t.out" [time out selection" C.I10]
parameter setting), the instrument returns automatically to the
normal display mode.
XKP-1-C2.p65 10/30/01, 9:37 AM 27