Super Systems 20PQ - Manual (Page 119)

115
Gr. P
- Event 1 enabling - [r.A04]
This parameter can be modified only when the selected program
is not running, it is not a linked program and output 1 is
configured as timer event, break event, end cycle or end profile
indicator.
Upper display: Pr. xx
where xx is the number of the selected
program
Range: "YES" the event 1 is used by the selected program
"no" the event 1 is NOT used by the selected program
NOTE: For Event 2 to Event 4 and for Event 10 to Event 19, the
instrument will show on the lower display the respective event
number and it will be possible to perform the same setting
described for Event 1.
- Program 1 - initial set point - [r.A05]
This parameter can be modified only when the selected program
is not running and it is not a linked program.
Upper display: Pr. xx
where xx is the number of the selected
program
Range: from rL (set point low limit [rE.12]) to rH set point high
limit [rE.13]).
Out of this range the display shows "ñEAS" and the
program will use the starting measured value as initial
set point value.
- Program 1 - Segment 1 - final set point
- [r.A06]
This parameter can be modified only when the selected program
is not running and it is not a linked program.
Upper display: xx.yy
where
xx is the number of the selected program
yy is the number of the selected segment
Range: from rL (set point low limit [rE.12]) to rH set point high
limit [rE.13]).
Out of this range the display shows "End" and the
program will be finished.
NOTES:
1) Setting "End" to the final set point of the first segment of
a program, the selected program will be deleted.
2) Setting "End" to the final set point of a segment, all
the next segments, if programmed, will be deleted.
3) If no segment is available (all the 200 segments are
used), the "End" indication will be automatically forced.
4) It is not possible to delete a program used in a linked
program or selected for automatic start.
XKP-1-C2.p65 10/30/01, 9:37 AM 115