Super Systems 20PQ - Manual (Page 144)

140
Calibration parameter errors
The instrument will show on the lower display one of the
following indications:
ñ.I.tc
= main thermocouple input calibration error
ñ.I.CJ = cold junction compensation error
ñ.I.rt = main RTD input calibration error
ñ.I.ñA = main mA input calibration error
ñ.I.5 = main 5V input calibration error
ñ.I.10 = main 10 V input calibration error
A.I.ñA = auxiliary mA input calibration error
A.I.5 = auxiliary 5V input calibration error
A.I.10 = auxiliary 10 V input calibration error
In.Ct = current transformer input calibration error
FEEd = electrical feedback input calibration error
05.ñA = output 5 mA calibration error
06.ñA = output 6 mA calibration error
When one of these errors is detected, contact your supplier.
Other errors
When during a program execution, a power failure occurs, at
power up the instrument displays this situation showing on the
upper display "E.600" indication.
Push one pusbutton to delete the "E.600" indication.
The instrument is also capable to detect the following errors:
E.100
Error during data saving in FRAM
E.110 Error in FRAM handling
E.500 Error during auto-zero measurement
E.501 Error during zero integrator measurement
E.502 Error during reference junction measurement. NOTE:
this error may be generated by an ambient temperature
higher than 70 °C (158 °F) or lower than -20 °C (-4 °F).
When one of these errors is detected, contact your supplier.
Two errors, related with the preliminary hardware setting, are
detectable:
3.
wrong position of the V301 dip switch.
8. wrong position of the V101 dip switch.
When one of these error is detected, the display blanks and the
error code is shown on most significant digit of the upper
display.
Remake V101 or V301 setting.
XKP-1-C2.p65 10/30/01, 9:37 AM 140