Super Systems 20PQ - Manual (Page 48)

44
CnF. 3
- Main output initial scale readout - [C.F09]
This parameter will be available only when "ñ.SCL" ("Main
control output in engineering units" [C.F07]) is set to "YES".
Range: from -199 to 999
NOTE: The Main output initial scale value can be higher than
the Main output full scale value.
- Main output full scale readout - [C.F10]
This parameter will be available only when "ñ.SCL" ("Main
control output in engineering units" [C.F07]) is set to "YES".
Range: from -199 to 999
- Main control output in engineering unit
- [C.F07]
This parameter will be available only when main control output is
configured.
Range: nO
= Scalable is not required
YES = Scalable is required
NOTE: This scaling allows you to display the output value in
engineering units instead of in percent.
- Main output decimal point position - [C.F08]
This parameter will be available only when "ñ.SCL" ("Main
control output in engineering units" [C.F07]) is set to "YES".
Range:
----.
= No decimal figure
---.-
= One decimal figure.
--.--
= Two decimal figures.
XKP-1-C2.p65 10/30/01, 9:37 AM 44