Super Systems 20PQ - Manual (Page 129)

125
HOW TO MODIFY A LINKED PROGRAM
When it is desired to modify a linked program it is necessary to
re-edit it.
HOW TO DELETE AN EXISTING LINKED PROGRAM
When it is desired to delete a simple program, it is sufficent to:
1) select the Group P (EDIT mode);
2) select the desired program;
3) select the first simple program and set the "End" indication,
then push the FUNC pushbutton. The display will show the
number of the selected program with the PRG LED flashing.
It is now possible to exit from edit mode.
HOW TO CHECK A PROGRAM
At the end of a program creation (simple or linked), it is possible
to verify if all the program parameters and the control param-
eters related to the selected program are correct.
This test may be manually activated by pushing "RUN" + "MAN"
pushbuttons.
If the program check is right, the lower display will show "O.K";
push any pushbutton.
If an error is detected, one of the following error messages will
be shown on the lower display:
E.A
error on time ramp selection [r.A03]
E.b error on initial set point [r.A05]
E.c error on number of program repetitions [r.A12]
E.d error on control type at the end of the program [r.A14]
and on control output at the end of the program
[r.A15]
E.E error on set point at the end of the program [r.A16]
E.F error on PID group selection at the end of the program
[r.A17]
E.G error on timer events [r.A18]
E.xxh error on final set point of xx segment [r.A06]
E.xxi error on xx segment duration [r.A07]
E.xxj error on xx segment gradient [r.A08]
E.xxk error in PID group selection of the xx segment [r.A09]
E.xxL error on tracking group selection of the xx segment
[r.A10]
E.yyP error on yy PID group
E.yyt error on yy tracking group
If the program check is done on a linked program, an additional
error code may be shown:
XKP-1-C2.p65 10/30/01, 9:37 AM 125